Reasons for difficulties in moving cable reel electric transfer carts

At present, the rapid development of industrial factories with the scale of production is getting bigger and bigger, in the plant between the workshops to carry out the transport of goods between the distance is also getting longer and longer, in order to make it more convenient to transport many manufacturers began to install in the plant transport tools, cable reel electric transfer car is one of them, it is powered by electricity speed uniform can transport heavy goods, is a good effect of the equipment. It runs on the track has a fixed running route, the user should pay attention to the way in order to make the equipment run longer.

Cable reel electric transfer carts are powered by a cable wrapped around a reel to power a flat car with more stable power. Many plants are using this type of equipment, but for proper operation, it should be operated correctly. The operator should check that there is no debris on the track and that all line switches are intact before working.

 The operation should be kept stable and slowly speed up. Cargo parts should be placed as evenly as possible and not piled on one side, otherwise, the centre of gravity will be unstable and the running shake will damage the flat car. Do not collide with the guardrail when decelerating and stopping in advance after reaching the target point, and wait for the cable reel electric transfer car to stop before changing the direction.

BJT electric transfer car is a common rail tram, which travels in the factory to transport various goods and is a guarantee of orderly production. Because its normal operation is important so generally manufacturers are more concerned about its operating condition and are more careful when using it, but sometimes there is a situation where the tram slips and has difficulty moving forward. What is the reason for this situation?

KPJ cable reel electric transfer car slipping situation is mainly because there are oil stains on the track, etc., the vehicle driving on top of the friction is reduced on the slipping situation. For this situation should be time to find the stained parts, they will clean up. You can also sprinkle some fine sand on the rail surface to increase the friction. If the track is not stained, it may be that the track is uneven and the wheels are not frictional when the tram is running to the sloping side. KPJ electric transfer vehicle skidding may also be a problem with the tram itself, the reason is similar to the track, the wheels are in contact with the rail surface oil or the wheels are not on a level surface.